Fellowes C14 Instrukcja Użytkownika Pobierz pdf (Strona 4)

Troubleshooting

If there is a problem with your shredder, check these symptoms and remedies. If you cannot

solve the problem, contact Fellowes customer service.

Do not open shredder head

attempt repair. You could be exposed to serious electric shock and will void the warranty.

tSymptom

Ready Light (F) will not light

Shredder does not start or stops

while shredding

Basket ajar/basket full

light (H) is on

Paper jam light (I) is on

Overheat light (J) turns on and

shredder will not operate.

Shredder sheet capacity decreases,

noise level increases, or cutting cylinders

stop with a squeak or rubbing sound

Shredder runs for a few seconds after the

paper has cleared the cutters

Remedy

Make sure shredder is plugged in and

the control switch (E) is in the automatic [I]

position.

• Make sure shredder is plugged in and

control switch (E) is in the automatic [I]

position.

• Shredder is jammed. Follow the

instructions under Operation.

Make sure the waste basket (A) is all the way

into the cabinet. Empty the waste basket.

Follow the instructions under Operation.

Clear the paper jam. Follow the

instructions under Operation.

Wait 40 minutes for shredder to cool down

before trying again.

Oil the cutting cylinders. Follow the

instructions under Maintenance.

No action required. This is a self-cleaning

function.

Supplies

The following items for the C14 shredders are available from Fellowes:

Item Quantity Part Number

Waste bags (in dispenser) 100/roll 36053

Powershred Lubricant 12 oz. bottle 35250

To purchase supplies, contact Fellowes at the appropriate location listed on the back page

of this instruction manual, or visit us at

www.fellowes.com

CDs, or DVDs

• Slide safety cover (L) to the right to expose the CD entry (M).

• Hold CD, or DVD at the edge and feed one at a time, straight into entry (M) releasing

when shredding begins. Shredder will stop when item has passed through entry. CDs and

DVDs will be shredded into small particles.

• Slide cover (L) to the left when done shredding media.

CAUTION:

Do not hold CD or DVD with finger through the center ring while feeding into

shredder.

To empty waste basket

If basket full light (I) is on, follow these steps until light turns off.

• Press control switch (E) to the off [O] position.

• Open the waste basket drawer (A) and remove full bag.

• Place new bag in basket, then slide drawer into cabinet (Fellowes plastic bag 36053).

• Press and hold control switch (E) in the reverse [R] position for a few seconds to clear

paper shreds that have collected under cutting cylinders.

• Alternate between automatic [I] and reverse [R] for a few seconds in each position.

CAUTION:

The shredder may be damaged if you alternate too rapidly between automatic

and reverse.

• Unplug shredder and remove wastebasket drawer (A).

– Carefully clear any paper shreds that have collected on under side of paper entry (C).

CAUTION:

Confetti-cut shredders have exposed blades.Use care when removing paper

shreds on underside of paper entry.

To clear a paper jam

If paper jam light (I) is on, follow these steps until light turns off.

• Check the waste basket and empty if full.

• Press and hold control switch (E) in the reverse [R] position to back paper out of paper

entry (C). Try pulling gently on paper to remove it from shredder.

• Alternate between automatic and reverse, if needed:

– Move control switch to automatic [I] and run for 1-2 seconds.

– Press and hold control switch (E) in the reverse [R] position for a few seconds.

– Continue alternating between automatic and reverse until the jam clears.

CAUTION:

The shredder may be damaged if you alternate too rapidly between

automatic and reverse.

Maintenance

Empty waste basket regularly

to ensure the smooth functioning of the cutting cylinders.

The shredder will not operate when the basket is full.

Oil regularly to ensure proper operation.

If used at or near daily capacity, apply oil every time you empty the basket.

Use Fellowes Powershred Lubricant #35250 or other non-aerosol vegetable-based oil in

a long-nozzle container (sample oil provided).

CAUTION:

Do not use flammable synthetic oil, petroleum-based products, or

aerosol lubricants of any kind.

To oil the cutting cylinders

• Apply oil over full width of cutting cylinders through the paper entry (C).

• Move control switch (E) to automatic [I] and run for 1-2 seconds.

• Press and hold the control switch (E) in reverse [R] for at least 3 seconds.

• Repeat the automatic/reverse sequence 3 or more times.

1 2 3 4 5

Komentarze do niniejszej Instrukcji

Brak uwag

Fellowes C14 Instrukcja Użytkownika Strona 4

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Niszczarki do papieru Fellowes C14